What is the problem? When I tell a gcode to copy to the SD card, nothing seems to happen. Also, can't seem to browse files on the SD card, though there are working print files on there.
Copying up a 13mb gcode sliced in cura (which will work if I copy it to the SD card via Windows) took about 10/15 minutes and failed with Upload failed Could not upload the file. Make sure that it is a valid file with one of these extensions: .g, .gco, .gcode, .stl - 504 Gateway Time-out
The server didn't respond in time.
What did you already try to solve it?
Not a lot yet if I am honest, as I have no idea what I could do. I understand it copies the gcode line by line so will be slower, but I have tried a few times and nothing seems to work.
Additional information about your setup (
OctoPrint version, OctoPi version, printer, firmware,
serial.log or output on terminal tab, ...)
OctoPrint 1.3.10 running on OctoPi 0.15.1
Creality CR-10S running stock F/W
Lots of entries in the terminal log that look like below (this is the end, no reported failure)
Recv: ok T:16.6 /0.0 B:16.3 /0.0 T0:16.6 /0.0 @:0 B@:0
Recv: ok T:16.7 /0.0 B:16.1 /0.0 T0:16.7 /0.0 @:0 B@:0
Recv: ok T:16.7 /0.0 B:16.4 /0.0 T0:16.7 /0.0 @:0 B@:0