What is the problem?
When connected, i get no info, and no ability to pause or cancel a print from the SD card, started from the printer (not from within octoprint)
What did you already try to solve it?
Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware,
serial.log or output on terminal tab, ...)
i very rarely use octoprint to start prints. granted im new to this, but im quite sure i remember seeing time remaining, and the pause/cancel buttons available on prints previously. im not sure exactly when this started, but i did just recently do the update to 1.3.9. Is this normal and i just never noticed before? Do the time estimates, and pause/cancel functions only work when a job is started from within octoprint?