2018-11-20 21:09:41,704 - serial.log is currently not enabled, you can enable it via Settings > Serial Connection > Log communication to serial.log 2018-11-20 21:10:35,895 - serial.log is currently not enabled, you can enable it via Settings > Serial Connection > Log communication to serial.log 2018-11-20 21:12:26,487 - serial.log is currently not enabled, you can enable it via Settings > Serial Connection > Log communication to serial.log 2018-11-20 21:43:05,503 - Enabling serial logging 2018-11-20 21:43:22,236 - Changing monitoring state from "Offline" to "Detecting serial port" 2018-11-20 21:43:22,259 - Serial port list: ['/dev/ttyACM0'] 2018-11-20 21:43:22,259 - Connecting to: /dev/ttyACM0 2018-11-20 21:43:22,263 - Changing monitoring state from "Detecting serial port" to "Opening serial port" 2018-11-20 21:43:22,267 - Connected to: Serial(port='/dev/ttyACM0', baudrate=115200, bytesize=8, parity='N', stopbits=1, timeout=10.0, xonxoff=False, rtscts=False, dsrdtr=False), starting monitor 2018-11-20 21:43:22,268 - Starting baud rate detection... 2018-11-20 21:43:22,268 - Changing monitoring state from "Opening serial port" to "Detecting baudrate" 2018-11-20 21:43:23,275 - Trying baudrate: 115200 2018-11-20 21:43:23,282 - Send: N0 M110 N0*125 2018-11-20 21:43:23,389 - Recv: start 2018-11-20 21:43:23,392 - Changing monitoring state from "Detecting baudrate" to "Operational" 2018-11-20 21:43:23,402 - Send: N0 M110 N0*125 2018-11-20 21:43:53,414 - Communication timeout while idle, trying to trigger response from printer. Configure long running commands or increase communication timeout if that happens regularly on specific commands or long moves. 2018-11-20 21:43:53,422 - Send: N1 M115*39 2018-11-20 21:44:23,419 - Communication timeout while idle, trying to trigger response from printer. Configure long running commands or increase communication timeout if that happens regularly on specific commands or long moves. 2018-11-20 21:44:23,428 - Send: N2 M21*18 2018-11-20 21:44:53,453 - No response from printer after 3 consecutive communication timeouts, considering it dead. Configure long running commands or increase communication timeout if that happens regularly on specific commands or long moves. 2018-11-20 21:44:53,463 - Changing monitoring state from "Operational" to "Offline (Error: Too many consecutive timeouts, printer still connected and alive?)" 2018-11-20 21:44:53,475 - Connection closed, closing down monitor