Bed Visualizer: Retrieve data from EEPROM and show visualization?

Plugins
1

Hi, with an Ender 3 V2 running Marlin 2.0.7x (nightly), after running a bed level using the hardware control and storing the data, is it possible to get Bed Visualizer to retrieve that data from EEPROM to show the visualize the bed level based on the last probe? Or, must one initiate the level using Bed Visualizer in order to see the bed level?

Thanks.

2

Just use M420 V in the settings for updating the mesh.

1 Like
3

Thank you. When you say "settings for updating the mesh", do you mean BV settings, General, "GCODE Commands for Mesh Update Process"? I would use M420 V rather than G29?

4

Yes, that's what I meant.

1 Like
5

Thank you, appreciate the guidance.