[Feature Request] Firmware Updater

I use a RUMBA32 board, but I need to connect the Boot and Reset pins to gpio to put the board into upload mode, so to enter upload mode the boot pin needs to be pulled high, and reset pulled low, and the general process to enter upload mode is hold boot press reset, whilst still holding boot, then release boot approx 1 to 2 sec after pressing reset. The board will be in upload waiting for a file.

So is it possible to get this change made to the plugin so I can get the updater to put the board into upload so I can upload the firmware from octoprint not an external computer

You might be better off posting this on the GitHub page, since not all plugin authors will spend the time crawling through the forums to find FRs. I know I probably wouldn't.