Host Action Commands

[spenc302]

What is the problem?

Installed 3d touch probe in my ender 3 v2 using crealitys official firmware and apparently it has host action commands are disabled, short of compiling my own version is there any way to solve this or does anyone know of a GitHub or something with the same download as creality official one?

What did you already try to solve it?

Reboot, safe mode, Reflashed firmware,

Have you tried running in safe mode?

Yes

Did running in safe mode solve the problem?

No

Systeminfo Bundle

You can download this in OctoPrint's System Information dialog ... no bundle, no support!)

octoprint-systeminfo-20240318215043.zip (33.3 KB)

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

Running octo4a 1.0.2 on a g6, with a ender 3 v2 and 3d touch probe
GD-Ender-3 V2-Marlin2.0.8.2-HW-V4.2.2-SW-V1.0.7_E_N_BLTouch firmware

[jcassel]

You might find something on the Facebook group:

New Ender-3 V3 - Profile Support

Facebook group might be able to help. At a glance it looks like it should be running some Marlin related firmware. If you look up the board in the Marlin examples and one exists for your printer, it's a good sign that even the stock firmware will work with Octoprint. Although many have had issues with Creality stock firmware. That said there are also PlugIns that have been created to help with that too.