To achieve a successful print, there are a lot of things to remember before you start printing:
- Did I load the right filament?
- Is enough filament left?
- Is the print bed free and clean?
- Is the right nozzle installed?
- Which sheet?
- Did I turn the stove off? Wait, no …
I would love to have a plugin that prompts these (or other) questions (configurable) after I hit the print button. To proceed with printing, I have to check each box.
This could prevent at least some failed prints or panically aborted prints.
Since my webbed skills are stuck in 2001, I would love to see somebody make this idea come to life.