I set up OctoPrint with Octolapse. But the test print got all blobby and the print head got stuck in the pla and could not move so I had to stop the print. Any idea how to fix this?
ikely to get help quickly ~~~~~ -->
What is the proble
I just set up Octoprint and Octolapse "successfully" but the prints keep stopping. They get stuck in the PLA on the print bed and I have to go and turn it off. What causes this and how do I fix it? I just want some nice timelapses.
What did you already try to solve it?
WRITE HERE
Nothing
Have you tried running in safe mode?
WRITE HERE
No
Did running in safe mode solve the problem?
WRITE HERE
No
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE
Blockquote
octoprint-systeminfo-20231126054929.zip (176.1 KB)