Printer goes to sleep after heating up

Hey guys, got the octoprint up and connected. But now I’m running into an issue I cannot make sense of. When I send a file to print with octopi, the printer heats up and when it get to temp, it puts the printer to sleep, which cause the z axis to raise all the way up and won’t atop till I pull the plug. Any help is appreciated

This would benefit from logs. Please enable serial logging, run through the usual course to produce the error and then get a Systeminfo bundle and upload it here.

1 Like

So I recommend to start a new thread in get help, not in General.

And don't forget to fill in the template :wink: