What is the problem?
error: subprocess-exited-with-error
× Getting requirements to build wheel did not run successfully.
│ exit code: 255
╰─> [1 lines of output]
Could not import OctoPrint's setuptools, are you sure you are running that under the same python installation that OctoPrint is installed under?
[end of output]
note: This error originates from a subprocess, and is likely not a problem with pip.
error: subprocess-exited-with-error
× Getting requirements to build wheel did not run successfully.
│ exit code: 255
╰─> See above for output.
note: This error originates from a subprocess, and is likely not a problem with pip.
RROR: You must give at least one requirement to wheel (see "pip help wheel")
What did you already try to solve it?
reinstall python venv, doublechecked octoprints venv
Have you tried running in safe mode?
no
Did running in safe mode solve the problem?
matter?
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
octoprint-systeminfo-20230423165422.zip (9,6 KB)
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
HW: odroid C4
OS: ubuntu 22-04 mini (opdated odroid image)
Installation: manual, depending to octoprints doc
User; odroid
venv: Python 3.10.7 ~/oprint
Octoprint Insallation succeeded without any errors
Octoprint startup looks fine also no errors
But I'm not able to install octoklipper after OP base installation.
klipper itself is also installed and up without any errors, of course from its own venv