Zupfe & Octoapp conflicting?

I noticed lately (not sure when this started) that I can't see files on Zupfe cause when loading it gives me a "xxxxx.gcode is not a G-Code file".
I also noticed that the first line on my gcode files reads "M118 E1 OCTOAPP_DISABLE_LAYER_MAXIC" and that lines makes Zupfe to give the error.
I tried commenting that line, but it get written again immediately, so I also disabled OctoApp and then Zupfe reads the file with no problem.

Am I doing something wrong or they do conflict with each other????

Hello @RomanR9999 !

You may contact

and