What is the problem?
Lately my Anycubic i3 stops heating the hotend and the heatbed, midprint and at random layers, on random prints. It just drops to roomtemperature.
But it keeps going like nothing happened and moves like it should till its done.
What did you already try to solve it?
- switched the mainboard
- checked all wires
- switched the hotend
- switched the heatbed
- sliced in different ways, used different models
Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible)
- Octoprint 1.4.0
- Anycubic i3 Mega ( 2 years old, never had such problems at all )
- Cura 4.5
No, I am at the point where I am clueless on what to do. Can't find any information on ppl who had the same problem and a solution to it. Mostly you find ppl who have broken wires at the heating elements...