A10T and octoprint after update

Get Help
1

Hello everyone,

I have a problem with octoprint and my A10T since the last update of octoprint.

My extruders are no longer recognized despite a good profile configuration.

I specify that before the update it worked well.

I got the following messages:

Invalid tool reported

Your printer reported tool T0 as invalid, reverting back to T0

Suppressed command

The command T0 was not sent to the printer:

Not queuing T0, that tool doesn't exist according to the printer profile or was reported as invalid by the firmware. Make sure your printer profile is set up correctly.

Thanks for your help.

2

Don't just delete the template please. It's there for a reason :slight_smile:

What is the problem?

WRITE HERE

What did you already try to solve it?

WRITE HERE

Have you tried running in safe mode?

WRITE HERE

Did running in safe mode solve the problem?

WRITE HERE

Systeminfo Bundle

You can download this in OctoPrint's System Information dialog ... no bundle, no support!)

WRITE HERE

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

WRITE HERE

Also remember to upload the systeminfo bundle :slight_smile:

1 Like
3

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.