I cannot access to boot partition of the Raspberry Pi on Mac. I only see "PI 1" on the Raspberry pi SD card that is empty. Is there a simple way to access the partition to edit the WIFI config information?
What did you already try to solve it?
Read this forum and didn't find a simple solution.
Have you tried running in safe mode?
NR
Did running in safe mode solve the problem?
Not relevant
Complete Logs
octoprint.log
, serial.log
or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
Not there yet
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
Latest version and Pi4 (if relevant)