After 1.4.1 Update, Octoprint will not load

What is the problem?

After Doing the 1.4.1 update via the web GUI, Octoprint will not load and it loads up to " The OctoPrint server is currently not running"

What did you already try to solve it?

ran ps -ef | grep -i octoprint | grep -i python but there was no response.
Ran :"~/OctoPrint $ ~/.octoprint/logs/octoprint.log"
Recieved response: "-bash: /home/pi/.octoprint/logs/octoprint.log: Permission denied"
Ran: "octoprint serve --safe"
Ran: " service octoprint status
● octoprint.service - LSB: OctoPrint daemon
Loaded: loaded (/etc/init.d/octoprint; generated; vendor preset: enabled)
Active: active (exited) since Wed 2020-08-05 06:30:41 EDT; 11min ago
Docs: man:systemd-sysv-generator(8)
Process: 7942 ExecStop=/etc/init.d/octoprint stop (code=exited, status=0/SUCCE
Process: 7950 ExecStart=/etc/init.d/octoprint start (code=exited, status=0/SUC
Tasks: 0 (limit: 4915)
CGroup: /system.slice/octoprint.service

Aug 05 06:30:41 CR-10S systemd[1]: Starting LSB: OctoPrint daemon...
Aug 05 06:30:41 CR-10S octoprint[7950]: Starting OctoPrint Daemon: OctoPrint.
Aug 05 06:30:41 CR-10S systemd[1]: Started LSB: OctoPrint daemon.
Rebooted the box.

Complete Logs

octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

OctoPrint version : 1.4.1
OctoPi version : 0.16.0
Printer : CR-10S, Marlin 1.1.9

Please find the logs! (< click the link) They will tell you what's wrong. And upload them here, so we can have a look