What is the problem?
BLtouch only partially deploys after last pi firmware update
What did you already try to solve it?
I've plugged in and reset all cords and wiring, checked all wiring, reset both printer and octopi
Have you tried running in safe mode?
no
Complete Logs
<smalserial.log (444 Bytes) octoprint.log (42.2 KB) l>octoprint.log
, serial.log
or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
Additional information about your setup
octoprint 1.5.2, JGmagic with bltouch and skr 1.4 turbo board, marlin 2.0