What is the problem?
Backpowering SKR mini e3 Ender 3 Mainboard, leeding to extremely hot steppers an therefore a huge cloq in the extruder.
What did you already try to solve it?
Its already solved, I just wanted to let others know, since i wasn't able to figure out how to reply to the backpowering list in the FAQ.
Have you tried running in safe mode?
WRITE HERE
Did running in safe mode solve the problem?
WRITE HERE
Complete Logs
octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE