Bed heating to 110 when nozzle starts to heat up

What is the problem?

The bed will start to heat to 110 when it is supposed to be at 60 when the nozzle starts to heat up to 200

What did you already try to solve it?

I have searched through settings like preheat temps and printer profiles

Have you tried running in safe mode?


Did running in safe mode solve the problem?


Systeminfo Bundle

You can download this in OctoPrint's System Information dialog ... no bundle, no support!)


Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible


Hello @Bigninjabeast !


What is this going to tell us?

  • A plugin is the culprit.


If you share this one in the next post, there is a greater chance to tell what is going on.

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.