What is the problem?
My gcode display has just started being offset
What did you already try to solve it?
checked printer profile, seems to be set right
Logs (octoprint.log, serial.log or output on terminal tab, ...)
Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, ...)
fully updated octopi
creality cr10s pro
creality slicer
Some additional details would be useful. Four screenshots of your OctoPrint printer profile. A smaller test case so that you could post the GCode output would help.
This kind of feels like one of those times when the OctoPrint printer profile's origin doesn't match up to reality... (center versus left/front)?
Thanks guys. Solved.
Weirdness. Looked at the printer profile 3 times. Looked again this morning and the bed size had rest to default 200x200
Regs
DD
