Bondtech ddx and octoprint

Get Help
1

What is the problem?

for a few years i have on my printer (creality cr10spro v2) de bondtech ddx and its working fine, but i want to put new octprint software in te printer but i remember from a few years ago i have to change somethig in the software steps??, where can i find the settings in octoprint

2

Do you mean the e-steps for the extruder?

3

yes, i no i have change this and if i no where it is in octoprint and i have the m code i van put this in the new software

4

Just send the gcode commands via the terminal and use the filters below if you want a clean output :slight_smile: