Camera v2 not working, stuck on webcam stream loading

My camera is a Raspberry camera module v2, and it used to work but now the control panel only displays "webcam steam loading..."

I tried restarting and once, there was a picture but now it is gone again.

Here is the only log i could figure out to find. I tried checking out the SD card, through windows viewer but couldn't find any other logs.
octoprint (3).log (36.2 KB)

I believe my problems may have come from me bundling the camera flex wire up with the power wires for my mk3s, which might have caused some problems? Anyway, I separated them and found that keeping them away from each other helped, in this case, the cable was also going by one of the stepper motors which might have contributed.