Can't turn on hotend heater

Get Help
1

What is the problem? Octoprint shows the file loaded but tool heater won't stay on

**What did you already try to solve it?**Disconnect Octopi and ran from SD card

Logs (octoprint.log, serial.log or output on terminal tab, browser error console ...)octoprint.log (82.1 KB) octoprint.log

Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ...)v 1.3.11 // Anycubic Kossel Linear Plus w/stock firmware // Safari on MacOS 10.14.6

2

Hi @petey!

Try without SD card in the printer. The serial.log would be quite handy too.

1 Like
3

It was operator error. I assumed that I could turn on both heaters at the same time. And it does auto-connect now. Sorry for the noobie mistake

1 Like