What is the problem?
We have a 3D printer with 2 extruders. T0 is the default, T1 is the secondary extruder. I want to set T1 to be the default if G-code file does not have T0 or T1 code.
What did you already try to solve it?
Checked the settings, searched for plugins, googled.
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
octoprint-systeminfo-20220719103146.zip (36.7 KB)
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
OctoPrint Version 1.8.1
OctoPi Version 0.18.0, running on Raspberry Pi 3 Model B Rev 1.2
Printer: LeapFrog Bolt Pro