What is the problem?
New to Octopi. Have an Ender 6 and looking for the PROPER way to hook up pi to Ender 6 to avoid power back feed. Any Ender 6 users that know how this is done without cutting wires and taping things. Tape comes off over time and causes problems.
What did you already try to solve it?
Have not hooked it up to USB yet for fear of power back feed.
Have you tried running in safe mode?
WRITE HERE
Did running in safe mode solve the problem?
WRITE HERE
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE