What is the problem?
I am trying to connect my Raspberry Pi 4 running OctoPrint to my Ender 6; however, I thought it would just work with everything set to auto on the web interface. Are there specific settings that I should be using for Serial Port and Baudrate?
What did you already try to solve it?
Plugged the micro usb into the port underneath the printer.
Have you tried running in safe mode?
No, I do not know how.
Did running in safe mode solve the problem?
Did not try
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE