Controls Homebutton

Get Help
1

Hello.

In the control Tab where you can control the x/y/Z Axis, there are these home buttons. Is there any way to set a standard for these? When i press the home button in the x/y area the print plate is going to the very rear of the printer and the print head is positioned on the lower left. But this makes it hard to remove the magentic print plate for cleaning or so. I would prefer it to go to the very front. Is there any way to set this to the home button?

Greetings
Sebastian

2

You have to distinguish between homing and parking.

Homing always goes to the position where the endstop switches are located.
And this is standard.

If you want a different position, you can use this

to create a button for your desired position.

3

Hello Ewald,
thanks a lot. That worked great :slight_smile:

1 Like
4

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.