Creality 1.1.5 silent board with Octoprint. Do I need to adjust baud rate? (Ender 3)

I'm currently on the standard 1.1.3 (I think), just purchased the Creality 1.1.5 silent version and it's on its way.

I stopped using Octoprint a while ago because sometimes it would disconnect from the Ender 3, the print would fail and or the quality of the prints were worse than printing from SD Card.

Apparently the fix was adjusting the baud rate in the firmware to allow for faster commands via USB.

I'm wanting to give Octoprint another chance with this new board. Do I need to adjust the baud rate on this board too, or is is 1.1.5 silent board already upgraded in that respect?

Any other fixes?

Cheers

how generous of you