i have a ender 3 max neo, that has a filament sensor, since ive had it connected to octopi it never detects when it runs out of filament, is there a way to toggle it on or do i need a plug in to make it work? any help would be great!
If you seek for help, please use the correct subforum.
I'll move it for you.
Please provide these informations:
What is the problem?
WRITE HERE
What did you already try to solve it?
WRITE HERE
Have you tried running in safe mode?
WRITE HERE
Did running in safe mode solve the problem?
WRITE HERE
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, .... as much data as possible
WRITE HERE
Thanks for moving it! I donโt use the forums often sorry.
What is the problem?
Filament sensor on my 3d printer does not recognize when it has run out of filament
What did you already try to solve it?
Tried searching plugins for filament sensors but all the ones I have found are for standalone sensors
Have you tried running in safe mode?
Yes
Did running in safe mode solve the problem?
No
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, .... as much data as possible
Ender 3 max Neo, with stock firmware
Using octopi running off raspberry pi 4 4gb
Version 1.9.2
Also using Obico to monitor
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.