Do not shutdown

Get Help
1

What is the problem?
If I cancel a print, or the print ends, OctoPrint ends the video and shuts down my Raspberry Pi. I lose remote access to it via SSH and have to power cycle it to turn it back on. Not good. I don't want my Pi to be shutdown.
How do I stop this?

What did you already try to solve it?
I don't have Automatic Stop installed, it was installed but I removed it.

Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, octoprint.log, serial.log or output on terminal tab, ...)
OctoPrint 3.10, Raspberry Pi 3 with WiFi

2

Obvoiusly something is configurated to shutdown the RasPi in that cases. Have a look on Octolapse, your Gcode scrips.
You can also try with Safemode if this occurs too. If not, it's obviously could be one of the plugins.

3

Obviously, but so far no luck. No OctoLapse, no modified GCode.
I am using Slic3r

4

Do we know if this also happens in Safe Mode (as suggested)?