Ender 3 Marlin error

Get Help
1

What is the problem?
Getting error: Heating failed, system stopped! Heater_ID:0 - Printer halted. Kill() called
This error I get for any reason like heat bed or move axis.

What did you already try to solve it?
Change the Marlin Firmware from 2.0 back to 1.1.9
Temperature Interval AUTOREPORT to 0

Logs (octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support!)
octoprint.log (112.1 KB)

Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible)
Octoprint Version 1.4.0
Octopi 0.17.0Marlin 1.1.9 with BLtouch
Safari - Mac OS 10.14.6 and
Google Chrome - windows 10
Using Raspberry PI 4B 4gg

2

Hi
Just fyi that error comes from marlin - not octoprint.

Are your heaters wired correctly ?
I don't see any heating at all

| Recv:  T:24.06 /0.00 B:23.63 /0.00 @:0 B@:0
| Recv:  T:24.18 /0.00 B:23.75 /0.00 @:0 B@:0
| Recv:  T:23.36 /0.00 B:24.37 /0.00 @:0 B@:0
| Recv:  T:23.95 /0.00 B:23.63 /0.00 @:0 B@:0
| Send: M104 S200
| Recv: ok
| Send: M140 S70
| Recv: ok
| Recv:  T:23.95 /200.00 B:24.06 /70.00 @:127 B@:0
| Recv:  T:23.67 /200.00 B:24.22 /70.00 @:127 B@:127
| Recv:  T:24.30 /200.00 B:23.40 /70.00 @:127 B@:127
| Recv:  T:24.65 /200.00 B:23.48 /70.00 @:127 B@:127
| Recv:  T:23.63 /200.00 B:23.59 /70.00 @:127 B@:127
| Recv:  T:23.87 /200.00 B:23.67 /70.00 @:127 B@:127
| Recv:  T:24.18 /200.00 B:23.52 /70.00 @:127 B@:127
| Recv:  T:24.18 /200.00 B:24.14 /70.00 @:127 B@:127
| Recv:  T:24.26 /200.00 B:23.52 /70.00 @:127 B@:127
| Recv:  T:24.06 /200.00 B:23.75 /70.00 @:127 B@:127
| Recv: Error:Heating failed, system stopped! Heater_ID: 0
| Recv: Error:Printer halted. kill() called!
1 Like
3

Shot in the dark: The printer board is powered by the Pi and the printer has no power at all...

2 Likes
4

I am embarrassed, the printer wasn't ON. :frowning:
Thanks @Ewald_Ikemann

1 Like