Ender 3 V2 Filament sensor

What is the problem?

I am able to connect to Octoprint and everything seems to be working except for my offical raspberry pi camera.

What did you already try to solve it?

I looked at the

Have you tried running in safe mode and if so did it solve the issue?

No and Im not sure what safe mode is?

Complete Logs

octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)

WRITE HERE

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

WRITE HERE

2 posts were merged into an existing topic: Ender 3 V2Filament sensor