What is the problem?
Ender 3 V2 powered from the Pi
is this normal?
I don't know if I use the term "normal" but it is typical of Creality printers. See https://community.octoprint.org/t/printers-known-to-have-backpowering-issues/25913/27.
You should isolate the RPi from the printer by either modifying your USB cable or using an adapter. See https://community.octoprint.org/t/put-tape-on-the-5v-pin-why-and-how/13574.
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.