Hello, Octoprint gives me this error every time I go to print and I don't know what it could be due to, does anyone know?
Printer Error MINTEMP triggered, system stopped! Heater_ID: 0 - Printer halted. kill() called!
Hello, Octoprint gives me this error every time I go to print and I don't know what it could be due to, does anyone know?
Printer Error MINTEMP triggered, system stopped! Heater_ID: 0 - Printer halted. kill() called!
When you opened this thread, there was this:
What is the problem?
WRITE HERE
What did you already try to solve it?
WRITE HERE
Have you tried running in safe mode?
WRITE HERE
Did running in safe mode solve the problem?
WRITE HERE
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE
Deleting that does not help.
Please try again
The problem is that every time I go to print the printer stops and gives me that error
I haven't tried anything because I don't know what I can try, but I think it's a printer problem. I've attached a photo of the error on the LCD screen.
And what's about the systeminfo bundle?
The systeminfo bundle would have really helped, but since there isn't one I have to ask.
Which temperatures are getting reported (hotend/bed)
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.