What is the problem?
I have a GeeeTech A10T, which is a three spool printer. Filament Manager is configured to allow me to select a specific spool from the spool database for each extruder. The correct number of extruders is set in Octoprint Setup, and the shared hotend flag is set.
Filament manager only tracks filament use for spool 0.
What did you already try to solve it?
Searched for similar issues on the forum. Checked configuration of Filament Manager and Octoprint
Complete Logs
octoprint.log
, serial.log
or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
octoprint Part 01.log (1.9 MB)
octoprint Part 02.log (2.2 MB)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
OctoPrint 1.42, GeeeTech A10T, Windows.
WRITE HERE