What is the problem?
I want to flash the firmware to an Ender3 from Octopi with OctoPrint-FirmwareUpdater
What did you already try to solve it?
The Marlin firmware has been installed via the traditional method and works fine but I would now like to try some extra settings, i.e. S curve acceleration and do not want to go through the whole process every time.
I just want to ask if anyone has experience with the octopi addin that allows flashing from octopi or am I barking up the wrong tree. Any advice will be greatly appreciated.
Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware,
serial.log or output on terminal tab, ...)