Geeetech A30T won't start

Get Help
1

<I have the latest Octoprint on a RP3 running an ender3 v2 just great but my Geeetech A30T doesn't start

The printer gets up to temperature starts with the initial line moves to the start of the print and just stops

I tried using different USB cables, a Raspberi Pi Zero 2 W, and a laptop with Linux installed
Turned the filamentdetector on or off.
The Beast.log (11.7 KB)

Logs (/var/log/webcamd.log, syslog, dmesg, ... no logs, no support)

Additional information about your setup (OctoPrint version, OctoPi version, ...)

2

Every time it is sending a G2 or G3 command the printer is sending back a strange response and there is a timeout. Maybe check that the firmware supports arc commands properly.

3

I turned off Arcwelder in Cura and Octoprint and had my first somewhat successful print. I'll keep you informed.

4

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.