What is the problem?
The estimated print times on Octoprint are way too inaccurate. On my last print Octoprint was estimating a print time of 5 hours and 22 minutes, while the total print time was actually of 7 hours and 5 minutes (32% more).
The profile I created on Octoprint was based on a post on Reddit, but I am not sure the parameters were right.
What did you already try to solve it?
Yesterday I gave the M503 command to my printer to check settings, and I got this output:
https://pastebin.com/i1weD1z2
So after that I went into Octoprint to check my parameters and I've found that are not the same:
So I'm not sure what parameter I should change to the profile, maybe these ?
Recv: echo:Maximum feedrates (mm/s):
Recv: echo: M203 X150.00 Y150.00 Z1.50 E50.00
Additional information about your setup
Printer: Monoprice Select Mini V2
OctoPi version: 1.4.0