Hi i just got a question about the Settings betqeen the Printer and Octoprint. I has set for example my esteps for the extruder in my printersettings, and set new values for bed level. Then i had instal ubuntu and Octoprint as a server. Everything work fine. But i am not sure if i start my print from Octoprint side if the settings like estep correction in my printer settings are recognized from Octoprint or must i set up esteps and other settings now again on Octoprint side? Thanks and regards, Thorsten
Hello @Just007 !
E-steps are not set in OctoPrint. They are set in the firmware, maybe in the start code of the slicer.
When the value is estimated, there is usually no need for changing it.
Thanks for the info. I wasnt sure if the settings in the firmware are recognized when i start a print not from sd card in my printer. When start the print from octoprint i didnt see any print on my printerdisplay expect the temperatur.
If you have a issue than you may have filled out the template when you opened this thread:
What is the problem?
WRITE HERE
What did you already try to solve it?
WRITE HERE
Have you tried running in safe mode?
WRITE HERE
Did running in safe mode solve the problem?
WRITE HERE
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support! )
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, .... as much data as possible
WRITE HERE
That is expected by default - the printer doesn't have knowledge of the print because OctoPrint sends it the gcode line-by-line.
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.