What is the problem?
only prints a quarter of the print in front left
What did you already try to solve it?
adjusted setting to center amd boundaries
Have you tried running in safe mode?
WRITE HERE
huh
Did running in safe mode solve the problem?
WRITE HERE
Complete Logs
octoprint.log
, serial.log
or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possiblenewest version creality 3 pro
WRITE HERE