Help with getting octoprint to show a camera

Camera model

Arducam fixed focus IMX219

What is the problem?

The camera is not displaying on the octoprint control page

What did you already try to solve it?

i put the "dtoverlay=imx219" in config.txt. i also followed all the instructions on this page: docs.arducam.com

Have you tried running in safe mode?

no because it is a fresh install

Did running in safe mode solve the problem?

n/a

Systeminfo Bundle

octoprint-systeminfo-20241020111927.zip (27.3 KB)

Additional information about your setup

OctoPrint version: 1.10.2, OctoPi version: newest version, Pi: Raspberry Pi zero 2 W printer: ender v3 se, firmware: stock, browser: firefox, operating system Windows,

WRITE HERE

Which one? There are two versions - one of them got the new camera stack

New camera stack