Homeing is moving over limits after a print was cancled

What is the problem?

I have a Qidi Tech X-Pro (Chitu Sailfish Firmware). The Octoprint is connected via the UART board on the motherboard.
Everything is working properly except when I cancel a print job and click on home all axis the Y-Axis will not stop on the Y Endstop it will stop when the X Endstop is reached.
This is really bad for my print and didn't found anything why this happens.

What did you already try to solve it?

I deactivated all 3rd Party plugins except Fix CBD Firmware (this is needed for me printer)

Have you tried running in safe mode?


Complete Logs

octoprint (1).log (1.3 MB)

Additional information about your setup

OctoPrint 1.5.2, Python 2.7.16, OctoPi 0.17.0

Hello @radaiko!

Do you have setup a script after cancelling in OctoPrint?
If yes: What's inside?


And please also share the serial.log from this issue. (You may have to enable serial logging)

1 Like

Sorry, I found the problem on my own. It wasn't octoprint.

A mod is too big to move to the reference point when the table is not moved to the bottom.

Thank you for your help.

1 Like