What is the problem?
I am trying to understand how to make corrections from the bed visualiser data, what i want to know is which wheel should i turn to correct the bed level
What did you already try to solve it?
i have completed the process and obtained the data but unsure which wheel to turn
Complete Logs
octoprint.log
, serial.log
or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE