I have OctoPi running on a Raspberry Pi 4 which offers both Cat-5 and WiFi connection. I would like to configure it so that octopi.local uses Cat-5 if available and falls back to WiFi if, for some reason, Cat-5 is not available. I can access either connection using an IP address but would prefer to use octopi.local if I can make this work.
OctoPi is working perfectly. My only concern/desire is to make octopi.local use my preferred network interface.
Thanks.
What did you already try to solve it?
I've looked at /etc/hosts, /etc/hostname, /boot/octopi-wpa-supplicant.txt, and a few other network related files. I've not seen where octopi.local is tied to any specific interface (ie: eth0 or wlan0). I have made no changes to anything yet.
Have you tried running in safe mode?
No, I don't know what this is. I'm accessing OctoPi from a Mac. I've heard of safe mode in Windows.
Did running in safe mode solve the problem?
No
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
Additional information about your setup
OctoPrint v 1.8.1
OctoPi Version 0.18.0, running on Raspberry Pi 4 Model B Rev 1.5
Printer: Ender 3 S1
Firmware: Marlin V1.0.5_C (Dec 28 2021 09:29:53)
Browser: Brave v 1.39.111
Operating System: MacOs 12.4