Camera model
Arducam
What is the problem?
So i just got a new raspberry pi 2 W and an arducam. I hooked the camera up to the raspberry pi via the camera cable, And now it says webcam sever not running, and when i go to the link it just says server error.
What did you already try to solve it?
I had it going once then the next it stops. I went to the tp-link web interference and open port 80, rebooted the router and still nothing. I then went to yougetsignal.com and it says that port 80 is still closed.
Have you tried unning in safe mode?
yes
Did running in safe mode solve the problem?
no
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
octoprint-systeminfo-20250428155255.zip (12.9 KB)
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
version is 1.11.0 i have a neptune 3 pro and im on chromium with a raspberry pi 2 w