Install octoprint on mks board

Hello everyone.
I have several unused Mks dlc32 boards and it has occurred to me that maybe a good use would be to use them as if they were a raspberry or similar and install octoprint to control 3d printers, but I don't know if it's feasible.
What is your opinion?
Thank you

Hello @Kargonsan !

These are dedicated printer driver boards.
I don't think you get a operating system installed on these to run OctoPrint.
They differ too much to a SOC board or a PC/laptop.

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.