LED Control for a Printer with build in LEDs (Davinci 1.0)

**I cracked my Davinci 1.0 with repetier firmware to get it working with cura, octoprint and filament of my choice.

So the Printer comes with LED lighting by default and at the printers buttons, I can switch the LEDs on and of (no hardware switch). Is it possible, to get control over the LED's via octoprint, because they are directly connected to my printer and not to the Pi **

I looked for plugins and at google, but I didn't find anything helpfull information.

I don't have any logs.

OctoPrint version 1.3.12
OctoPi Version 0.17.0
running on Raspberry Pi 3 Model B Rev 1.2
Davinci 1.0
Repetier 0.92.10

Firefox 72.0.1 (64 bit)
Win 10 Pro 64 bit

Have you seen/tried this:

Suggests that M355 S1 turns on lights, M355 S0 turns it off