Logitech C270 camera won't show up on Octopi

Camera model

Logitech C270

What is the problem?

My Logitech C270 won't show up on Octoprint's GUI. By GUI I mean the standard interface not the dashboard plugin

What did you already try to solve it?

Different USB port

Have you tried running in safe mode?

Yes

Did running in safe mode solve the problem?

No

Systeminfo Bundle

octoprint-systeminfo-20250320190756.zip (298.6 KB)

Additional information about your setup

Latest Marlin of printer (Ender 3 just normal original Ender 3)
Latest OctoPi + OctoPrint version
Logitech C270

WRITE HERE

Please actual Version numbers - latest can be different tomorrow.


What are your settings in OctoPrint Settings -> Plugins -> Classic Webcam?

My Apologies. I believe my issue may have been caused by an under voltage. As when I plugged in the webcam without my printer plugged in then it shows up just fine. My solution was putting a tiny bit of electrical tape over the right most pin of the USB cable (This is for the cable of my printer, not the camera)

1 Like