Losing connect about 5% into print

Get Help
1

What is the problem? - Losing connection seventh time in a row at about 5% through the print.

What did you already try to solve it? - Restarting wifi router, Restart Raspberry Pi 4 with Octoprint, restated my Creality Ender 3 Pro 4.2.2., replaced USB cable with a new data usb cable

Logs (syslog, dmesg, ... no logs, no support) - Communication e - There was communication error while talking to you printer. Please consult the terminal output and Printer requested line 2767 but no sufficient history available, can't resend.:

Additional information about your network (Hardware you are trying to connect to, hardware you are trying to connect from, router, access point, used operating systems, ...) Wifi

2

That's not an issue with your network, that's an issue with the communication with your printer via serial.

Fill this out:

What is the problem?

WRITE HERE

What did you already try to solve it?

WRITE HERE

Have you tried running in safe mode?

WRITE HERE

Did running in safe mode solve the problem?

WRITE HERE

Complete Logs

octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)

WRITE HERE

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

WRITE HERE