Multicam Worked...And Then It Didn't

Camera model
Arducam 8MP IMX219 SKU B0329
ELP 2.1 5MP

What is the problem?
This setup worked for quite awhile without issue and now the Arducam won't show any feed, assuming the timeouts in the webcamd log pertain to this camera, and the ELP will randomly stop showing a feed until the page is refreshed. I'm primarily concerned with resolving the Arducam as that's my nozzle cam.

What did you already try to solve it?
Tested camera on Windows PC, feed comes up fine. Tried a different USB extension, tried a different USB port on this PI.

Logs (/var/log/webcamd.log, syslog, dmesg, ... no logs, no support)

Additional information about your setup (OctoPrint version, OctoPi version, ...)
Raspberry PI 4B (Using official power supply)
OctoPrint 1.7.3