No slow speed on first layers after latest build

Get Help
1

The slower speed from slicer settings (Cura or PrusaSlicer) does not affect speed after latest build

Print from SD -card, works

Logs (octoprint.log, serial.log or output on termioctoprint.log (61.6 KB) octoprint.log.zip (8.2 KB) octoprint.log.zip (8.2 KB) nal tab at a minimum, browser error console if UI issue ... no logs, no support!)

Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible)

2

Octoprint doesn't change the speed. It just sends what your slicer has generated.

A plugin could interfere with your gcode.

Test the safe mode to rule this out.